Mount compact 12V step and deck lights in the riser, or in the stringer on open stairs, on every other step and always on the first and last. Drill a hole the size of the fixture, connect the lead with a waterproof connector, and run the cable out of sight under the deck.
Riser, stringer or post?
How many deck stair lights?
- Every other step on stairs up to about 4 ft wide, plus the first and last step.
- Two per riser on wider stairs, roughly 3–4 ft apart.
- Short runs of 2–3 steps: light every step; there are too few to skip.
- Stringer lights: one per step on one side, or staggered on both sides of wide stairs.
For a deeper look at spacing and color, see the main step lighting guide.
Chapter 03How to install a deck stair light
- Plan the cable route under the deck before you drill. Every light should be reachable from below.
- Drill the hole with a spade or Forstner bit sized to the fixture body, centered on the riser board.
- Pull the cable through from underneath, leaving a small loop of slack.
- Connect the fixture lead to the cable with a waterproof connector.
- Push the fixture in and fasten it with the screws provided, using stainless screws on wood.
- Staple the cable along the joists under the deck, away from where people store things or walk.
On composite decking, check the board is solid where you drill. Some hollow composite boards need a block behind the hole so the screws have something to bite into.
Pick the right deck light
Deck lights are small and close to feet, so glare matters more than brightness. Look for a hood or louvered face that keeps the light pointed down, warm white 2700K–3000K, and solid brass, which will not rust or rot with the wood around it. Cardon brass deck lights come in natural bronze and black to match the railing.
Chapter 05Power the deck
Deck lights are low-wattage, so one transformer can usually handle the stairs, the posts and some path lights. Add up all the watts and multiply by 1.3: twelve 3W deck lights is 36W × 1.3 ≈ 47W, so a 75W transformer works. Mount the transformer near a GFCI outlet, ideally where you can reach the timer. For long runs to the far end of the yard, check the wire gauge guide.
Questions we hear most
Where should lights go on deck stairs?
Low on the riser of every other step, plus the first and last step. On open stairs without risers, mount them in the stringer.
How do you wire deck stair lights?
Run 12V low-voltage cable under the deck from the transformer, pull it through a hole at each light, and connect each fixture with a waterproof connector.
What size hole do I drill for a deck light?
It depends on the fixture. Check the cut-out size on the product page or spec sheet and use a matching spade or Forstner bit.
Should deck lights be on every step?
Not usually. Every other step looks calmer and saves wiring. Short stairs of 2–3 steps are the exception.
What color light is best for a deck?
Warm white, 2700K–3000K. It flatters wood and matches the light coming from the house.





