How to Choose a Transformer

Every 12V landscape lighting system needs a transformer and wire. Pick the transformer by the total watts of your lights plus a 30% safety margin, and pick the wire by how far your farthest light is. Use the calculator below, or read the step-by-step guide.

Transformer & wire calculator

Enter your lights and the distance to the farthest one. We add a 30% safety margin.

Total
With 30% margin
Voltage at last light

Rule of thumb, worst case with all lights at the end of one run on the 15V tap. Check each fixture's specs and measure 10–15V at every light after installing.

How it works, step by step

1. Add up the watts of your lights

Add the wattage of every lamp that will run on the transformer. For example, 6 spotlights with 5W LED bulbs are 30W. If a fixture lists a VA rating, use that number: LED drivers often draw a little more VA than their watts.

2. Add a 30% safety margin

Multiply your total by 1.3 and choose a transformer at least that size. 30W × 1.3 = 39W, so a 75W transformer is a good fit. The margin keeps the transformer running cool, at under 80% of its capacity, and leaves room to add lights later.

TransformerTotal light watts (up to)About how many 5W lights
75W57W11
150W115W23
200W153W30
300W230W46
600W461W92
900W692W138

3. Size the wire by distance

Voltage drops along the cable: the longer the run and the more watts on it, the dimmer the last light. We size wire for the worst case, with all the lights at the far end of the run:

Voltage drop = 2 × length (ft) × watts ÷ cable constant
Cable constants: 14 AWG = 4,700 · 12 AWG = 7,490.

Keep at least 11V at the last light when using the 15V tap. Each run also has a maximum load: 144W on 14 AWG and 192W on 12 AWG. Never connect 16 AWG cable directly to the transformer.

Watts on one run14/2 wire, max distance12/2 wire, max distance
20W470 ft749 ft
50W188 ft299 ft
100W94 ft149 ft
150WOver the 144W limit99 ft

Buy about 15% more cable than the measured distance for bends and connections. If one run can't reach, split your lights into two or more runs from the transformer.

4. Use the multi-tap outputs

Multi-tap transformers have 12V, 13V, 14V and 15V outputs. Use the higher taps for longer runs so the far lights still get enough voltage. After installing, check with a voltmeter that every light gets between 10V and 15V.

Not sure? Call us at 949-381-5333 and we'll size your system with you.