Bulbs · 3 min read

LED vs Halogen Landscape Lighting: Which Is Better?

LED vs halogen for landscape lighting: energy use, bulb life, light quality and what changes in your transformer and wire when you switch to LED.

LED vs Halogen Landscape Lighting: Which Is Better?
In this guide
    Quick answer

    LED wins for almost every yard. It uses roughly 75–85% less power than halogen, lasts many times longer, runs cool, and comes in the same warm 2700K–3000K color. Switching is usually as simple as swapping the bulb for a 12V LED of the same base.

    Chapter 01

    LED vs halogen at a glance

    LED Halogen
    Power for similar light About 4–7W About 20–50W
    Typical life Tens of thousands of hours A few thousand hours
    Heat Warm to the touch Very hot
    Color 2700K or 3000K, stays consistent About 3000K, shifts as it dims
    Transformer load Small, more lights per transformer Large, needs bigger transformers and thicker wire
    Upfront cost Higher per bulb Lower per bulb
    Chapter 02

    Why LED wins for most yards

    • Lower power bills. A yard of twenty 35W halogens draws 700W; the same yard in 5W LEDs draws about 100W.
    • Far fewer bulb changes. Halogens burn out every year or two of nightly use. Quality LEDs last for many years.
    • Smaller transformer and less voltage drop. Fewer watts means a smaller transformer and wire runs that can go much farther.
    • Cooler fixtures. Safer for kids, pets and plants near the fixture.
    Chapter 03

    Where halogen still shows up

    Halogen bulbs cost less up front and some people like the exact way they dim. In practice, the higher running cost and constant replacements cancel the savings within a season or two, and most new landscape fixtures are designed around LED.

    Chapter 04

    How to switch from halogen to LED

    1. Identify the bulb base (MR16, MR11, PAR36, G4, BA15 or T10). See which bulb fits.
    2. Match the brightness, not the watts. A 5W LED MR16 roughly replaces a 20–35W halogen; a 7W replaces about 35–50W.
    3. Keep the beam angle and color close to what you had, so the look does not change.
    4. Recheck the transformer. Add up the new LED watts and multiply by 1.3. You will likely have room to add lights.
    5. Check the voltage at the last light. LEDs like 11–15V. If an old system was set to a high tap for halogens, a lower tap may suit the LEDs better.
    Pro tip

    Change every bulb on a run at the same time. Mixing halogen and LED on one run makes the colors and brightness uneven.

    Questions we hear most

    Is LED better than halogen for landscape lighting?

    For most yards, yes. LED uses far less power, lasts much longer, runs cooler and comes in the same warm color.

    Can I put LED bulbs in my halogen landscape fixtures?

    Usually yes, as long as the LED has the same base and is rated for 12V landscape use.

    What LED replaces a 35W halogen MR16?

    A 5–7W LED MR16 gives similar light to a 35W halogen.

    Do I need a new transformer for LED landscape lights?

    Usually not. Most halogen transformers work with 12V LED bulbs, and the lower load leaves room to add more lights.

    Plan your system

    Power your lights

    Size the transformer at your total watts × 1.3, and use 12/2 wire on longer runs.

    Shop the guide

    All LED bulbs ›

    Need help planning your lighting?

    Send us a photo or call. We’ll tell you exactly what to buy.

    Call 949-381-5333

    Keep reading